VS type Anderson VERSA-SEAL®, non-gritted electrical electrical joint compound is UL listed for all alumium and copper applications, such as pad-to-pad surfaces.

VSG type Anderson Versa-Seal®, gritted electrical joint compound is UL listed for all aluminum and copper compression connections. It is not recommended for use as a lubricant on threaded fittings as improper torque values or thread galling may occur.

• VS is a non-petroleum, non-toxic non-gritted compound for use where EPDM, natural rubber, as well as polyethylene insulating products may come in contact with the sealant.
• VSG is a non-petroleum, non-toxic gritted compound for use where EPDM, natural rubber, as well as polyethylene insulating products may come in contact with the sealant.
• VS is recommended for bolted joints, flat-to-flat contact surfaces, terminal and lug tongues, grooves of bolted parallel connectors or hot-line clamps, lubricating insulating sleeves and caps, and for improving electrical conductivity on all metallic conduit threads.
• VSG is recommended for NEMA minimum tension compression terminals. VSG helps break oxide films on contact surfaces while enhancing conductivity between conductor strands with its conductive grit. Also for two-piece full tension dead-ends and sleeves.
• Yellow tint for VS identification.
• Blue tint for VSG identification.

See application guide for more information.

See table labeled "Inhibitor Application Guide" for part number selection.

Type 155, Anderson Versa-Seal® electrical joint compound is recommended for use on all bare aluminum and copper application, and is a petroleum based formulation.

155 is recommended for flat-to-flat and grooved bolted connections.

Tan tinted color.

See application guide for more information.

See table labeled "Inhibitor Application Guide" for part number selection.

ING series Inhibox non-gritted, non-toxic electrical joint compound is recommended for rigid bus connections between aluminum-to-aluminum and aluminum-to-copper applications.

• Non-gritted with zinc flakes.
• Non-rubber swelling, electrically conductive contact aid and sealant.
• Recommended for flat-to-flat contact surfaces.
• Improves electrical continuity for grounding on threaded metal conduit.

See application guide for more information.
See table labeled "Inhibitor Application Guide" for part number selection.

I220 series Inhibox gritted, non-toxic electrical joint compound is recommended for aluminum and copper compression connections. It is not recommended for use as a lubricant on threaded fittings as improper torque values or thread galling may occur.

• Contains aluminum oxide grit and zinc flakes to create fresh metal interfaces.
• Non-rubber swelling, electrically conductive contact aid and sealant.
• Recommended for bolted connectors and non-tension compression connectors on cable conductors.
• Not recommended as a lubricant.

See application guide for more information.
See table labeled "Inhibitor Application Guide" for part number selection.