For sales and support visit:
hubbellpowersystems.com/contact/

Home › Products › Connectors › Transmission › Dampers › Installation Information

Installation Information

"4-R" DAMPER
INSTALLATION INSTRUCTIONS FOR VIBRATION DAMPERS

  1. Dampers shall be located from the center of the damper clamp to either the dead end or the suspension support as shown above.
  2. The orientation of the damper weights along the conductor is optional. For convenience, orient the damper such that the clamp bolt head faces the installer.
  3. When only one damper is required per conductor per span, it can be installed at either span extremity when the support hardware is identical. When support hardware differs, place the damper at the suspension structure.
  4. When two dampers are required per conductor per span, the preferred placement is one at each span extremity.

Hubbell Power Systems All contents Copyright© 2001 - Hubbell Incorporated. All rights reserved. Because Hubbell has a policy of continuous product improvement, we reserve the right to change design specifications without notice.
Terms of Use | Contact Us | Site Map
Connectors