• Storage Bag Included
• Tested per OSHA & ASTM F711

Flag-Hoisting Principle

The Chance Power-Fuse Lift Stick tool removes and installs power fuse holders weighing up to 50 pounds. It is equipped with an arrangement of ropes and pulleys that permit the operator to lower and raise a power fuse holder in much the way a flag is handled on a flagpole. The operator has complete control of the fuse holder at all times, and doesn't have to balance and lift dead weight as must be done with the fuse on the end of the hookstick.

Fuse Mount Supports Tool

During the removal and replacement of fuse holders, the fuse mount supports both the weight of the fuse holder and the tool. The pole hangs free while the operator automatically steadies it during the raising or lowering operation. Only during the actual opening and closing of the power fuse does the operator support the weight of the tool. A disconnect prong is located on the bottom ferrule of the tool.

Soundly Constructed

While this tool is soundly constructed to support heavy fuse holders (up to 50 pounds); it is relatively light in weight. The Epoxiglas® pole is tested to assure its insulating strength. Operating lines are polypropylene rope. Carrier bands and shepherd hook attachments are coated with plastisol.

How to Order -

Select one of the Power Fuse Lift Sticks from Table l, based on the desired pole length.

TABLE I - POWER-FUSE LIFT STICK
Each includes an all-weather storage bag.

Catalog No.	Diameter and Overall Length	Weight
H422114	1-1/2" x 14' 1"	10-1/4 lb.
H422116	1-1/2" x 16' 1"	11-1/4 lb.

Then, in Table II, find the applicable Power Fuse Type and select the Fuse attachment that is
to be installed at the top of the Lift Stick.

TABLE II - POWER FUSE ATTACHMENTS

Catalog No.	For Power Fuses	Weight
M4221	S&C SM, Size 5	14 oz.
M42212	S&C SMD; West'g're BA & DBA; GE. EF-1, EF-1B & EF-2B	1-1/8 lb.
M42213	S&C SM & HSO; S.S. HBA & BTA; West'g'e BA & DBA; G.E. EF-1, EF-1B, & EF-2	1-1/2 lb.

Finally, in Table III, again find the applicable Power Fuse type and select the Lift Finger to be
installed on the Carrier.

TABLE III - CARRIER LIFT FINGERS

Catalog No.	For Power Fuses	Weight
M42191	West'g' BA & DBA; S&C SM, SMD, & HSO; G.E. EF-1, EF-1B & EF-2	4 oz.
M42192	S.S. HBA & BTA	7 oz.