For sales and support visit:
hubbellpowersystems.com/contact/

Home › Products › Switching › Distribution › Cutouts › Porcelain › Cutout-Arrester Combinations

Cutout-Arrester Combinations

Over-the-Arm Type only


Advantages of combination

Chance cutout-arrester combinations cost less than the total cost of separately purchased components. The combination units install faster, more economically and take up less space in storage, transit and service. Each combined unit takes up a minimum of space on the crossarm and has a favorable weight distribution for minimal off-center loading. The fieldproven quality of both cutout and arrester assure consistent high performance for the combinations.

These units include Chance cutouts fitted with only Ohio Brass® MOV arresters, superseding previous silicon-carbide units. For easy conversion to the new arrester designation system, refer to the Cutout Cross-Reference Guide, Bulletin 10-0203.

kV LIW (BIL) E G
110 22" (559 mm) 23-3/4" (603 mm)
125 26-3/4" (679 mm) 25-1/2" (648 mm)
150 26-3/4" (679 mm) 25-1/2" (648 mm)
170 32-1/2" (826 mm) 28" (711 mm)

Ordering Information

To specify a Cutout-Arrester Combination:

  1. Select a two-letter designation for the
    appropriate arrester from the shaded
    section of the Table at left.
  2. Substitute the two letters for the "0" in
    the Base Catalog No. for the appropriate
    Cutout listed on page 6, 10 or 12.
Hubbell Power Systems All contents Copyright© 2001 - Hubbell Incorporated. All rights reserved. Because Hubbell has a policy of continuous product improvement, we reserve the right to change design specifications without notice.
Terms of Use | Contact Us | Site Map
Switching